Talkaphone WEBS-MT/R Radius Emergency Phone Tower with WEBS Manual de usuario descargar pdf (Pagina 2)

WEBS-MT/R Tower Installation Instructions

Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804

Phone 773.539.1100 • Fax 773.539.1241 • info@talkaphone.com • www.talkaphone.com

All prices and specifications are subject to change without notice.

Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.

WEBS-BACKUP (optional)

QTY

Part Number

Description

86383

WEBS-UPS

68594

12VDC Battery

25192

Mounting shelf for battery

4247

Screws #8-32 x 0.5”L

4248

Hex nut #8-32

42767

#10 round hole washer

III. Physical Installation

1. Install one 3/4” nut and one washer on each anchor bolt 2.5”-3.5" above grade to top of washer. This

will allow for a 1/2" air gap between the foundation and the tower which will allow airflow and prevent

moisture problems. Verify that the nuts are level (0° pitch).

NOTE: To insure proper grounding of all electrical components, the tower mount should be effectively earth grounded

from the grounding stud (located across from the lower access panel) with 6 AWG or better insulated, stranded copper

wire to the metallic power service raceway (conduit) or an 8' or longer corrosion-resistant ground spike.

2. After removing the lower access panel of the tower, install the tower onto the bolts with the

Emergency Phone opening oriented in the desired direction. Install second set of nuts and washers.

Tighten the upper nuts; the bottom set is only for leveling.

1 2 3 4 5 6 7 8 9

Sin comentarios

Talkaphone WEBS-MT/R Radius Emergency Phone Tower with WEBS Manual de usuario Pagina 2